An unconformity is a buried erosional or non-depositional surface separating two rock masses or strata of different ages, indicating that sediment deposition was not continuous. In general, the older layer was exposed to erosion for an interval of time before deposition of the younger layer, but the term is used to describe any break in the sedimentary geologic record . The significance of angular unconformity (see below) was shown by James Hutton , who found examples of Hutton's Unconformity at Jedburgh in 1787 and at Siccar Point in Berwickshire in 1788, both in Scotland.
6-554: The Kukri Peneplain is a near-horizontal and flat unconformity in the Transantarctic Mountains . The peneplain formed by erosion of the granitic and metamorphic basement rocks during the Paleozoic ( Silurian to Devonian ). Kukri Peneplain dips gently to the west. 84°52′43″S 174°17′50″W / 84.87861°S 174.29722°W / -84.87861; -174.29722 This Antarctica -related article
12-454: Is a stub . You can help Misplaced Pages by expanding it . This geology article is a stub . You can help Misplaced Pages by expanding it . Unconformity The rocks above an unconformity are younger than the rocks beneath (unless the sequence has been overturned). An unconformity represents time during which no sediments were preserved in a region or were subsequently eroded before the next deposition. The local record for that time interval
18-477: Is missing and geologists must use other clues to discover that part of the geologic history of that area. The interval of geologic time not represented is called a hiatus . It is a kind of relative dating . A disconformity is an unconformity between parallel layers of sedimentary rocks which represents a period of erosion or non-deposition. Disconformities are marked by features of subaerial erosion. This type of erosion can leave channels and paleosols in
24-523: The overlying horizontal layers. The whole sequence may later be deformed and tilted by further orogenic activity. A typical case history is presented by the Briançonnais realm (Swiss and French Prealps) during the Jurassic. Angular unconformities can occur in ash fall layers of pyroclastic rock deposited by volcanoes during explosive eruptions . In these cases, the hiatus in deposition represented by
30-543: The rock record. A nonconformity exists between sedimentary rocks and metamorphic or igneous rocks when the sedimentary rock lies above and was deposited on the pre-existing and eroded metamorphic or igneous rock. Namely, if the rock below the break is igneous or has lost its bedding due to metamorphism, then the plane of juncture is a nonconformity. An angular unconformity is an unconformity where horizontally parallel strata of sedimentary rock are deposited on tilted and eroded layers, producing an angular discordance with
36-526: The unconformity may be geologically very short – hours, days or weeks. A paraconformity is a type of unconformity in which the sedimentary layers above and below the unconformity are parallel, but there is no obvious erosional break between them. A break in sedimentation is indicated, for example, by fossil evidence. It is also called nondepositional unconformity or pseudoconformity. Short paraconformities are called diastems . A buttress unconformity also known as onlap unconformity, occurs when younger bedding
#883116