The ATmega328 is a single- chip microcontroller created by Atmel in the megaAVR family (later Microchip Technology acquired Atmel in 2016). It has a modified Harvard architecture 8-bit RISC processor core.
4-782: The Atmel 8-bit AVR RISC -based microcontroller combines 32 KB ISP flash memory with read-while-write capabilities, 1 KB EEPROM , 2 KB SRAM , 23 general-purpose I/O lines, 32 general-purpose working registers , 3 flexible timer/ counters with compare modes, internal and external interrupts , serial programmable USART , a byte-oriented 2-wire serial interface, SPI serial port, 6-channel 10-bit A/D converter (8 channels in TQFP and QFN / MLF packages), programmable watchdog timer with internal oscillator , and 5 software-selectable power-saving modes. The device operates between 1.8 and 5.5 volts. The device achieves throughput approaching 1 MIPS /MHz. A common alternative to
8-643: The ATmega328 is the "picoPower" ATmega328P. A comprehensive list of all other members of the megaAVR series can be found on the Atmel website. ATmega328 is commonly used in many projects and autonomous systems where a simple, low-powered, low-cost micro-controller is needed. Perhaps the most common implementation of this chip is on the popular Arduino development platform, namely the Arduino Uno , Arduino Pro Mini and Arduino Nano models. Reliability qualification shows that
12-486: The chip erase. Wait until RDY/BSY (PD1) goes high. XA1:XA0:BS1:DATA = 100 0001 0000 , XTAL1 pulse, pulse WR to zero. This is the flash write command. And so on. Serial data to the MCU is clocked on the rising edge and data from the MCU is clocked on the falling edge. Power is applied to V CC while RESET and SCK are set to zero. Wait for at least 20 ms and then the programming enable serial instruction 0xAC, 0x53, 0x00, 0x00
16-485: The projected data retention failure rate is much less than 1 PPM over 20 years at 85 °C or 100 years at 25 °C. Programming mode is entered when PAGEL (PD7), XA1 (PD6), XA0 (PD5), BS1 (PD4) is set to zero. RESET pin to 0 V and V CC to 0 V. V CC is set to 4.5–5.5 V. Wait 60 μs, and RESET is set to 11.5–12.5 V. Wait more than 310 μs. Set XA1:XA0:BS1:DATA = 100 1000 0000 , pulse XTAL1 for at least 150 ns, pulse WR to zero. This starts
#338661