Misplaced Pages

#293706

29-429: A lugger is a sailing vessel defined by its rig , using the lug sail on all of its one or more masts . Luggers were widely used as working craft, particularly off the coasts of France , England , Ireland and Scotland . Luggers varied extensively in size and design. Many were undecked, open boats, some of which operated from beach landings (such as Hastings or Deal ). Others were fully decked craft (typified by

58-411: A boom; most working craft were boomless to allow more working space. The dipping lug never uses a boom. A dipping lug has to be moved to the leeward side of the mast when going about, so that the sail can take a good aerodynamic shape on the new tack. There are several methods of doing this, one of which is to simply lower the sail, manhandle the yard and sail to the other side of the mast and re-hoist. All

87-437: A crane and are typically stepped on the keel through any cabin or other superstructure. Many sailboats have an alternate means of propulsion, in case the wind dies or where close maneuvering under sail is impractical. The smallest boats may use a paddle ; bigger ones may have oars ; still others may employ an outboard motor , mounted on the transom; still others may have an inboard engine . Monohull A monohull

116-445: A dipping lug is usually made fast to the weather gunwale, thereby allowing the mast to be otherwise unstayed. A common arrangement is to have a dipping lug foresail and a standing lug mizzen. This arrangement is found on many traditional British fishing vessels, such as the fifie , but there are examples of dipping lugs on two masts or standing lugs on two or three masts (as in the chasse-marée). A standing lug may be used with or without

145-407: A jib. Most modern designs have only one sail, the mainsail; however, the traditional catboat could carry multiple sails from the gaff rig. Catboat is a charming and distinctive sailboat featuring a single mast with a single large sail, known as a gaff-rigged sail, and a broad beam that ensures stability. This type of vessel, named after the "cat" tackle used in sailing, has a rich history dating back to

174-431: A lot of weight in two "wings" which run sideways from the main part of the keel. Even more recent is the concept of canting keels , designed to move the weight at the bottom of a sailboat to the upwind side, allowing the boat to carry more sails. A twin keel has the benefit of a shallower draft and can allow the boat to stand on dry land. Multihulls, on the other hand, have minimal need for such ballast, as they depend on

203-411: A reduced draft, with a much reduced underwater profile. This, in turn, results directly in reduced wetted surface area and drag. Without a ballast keel, multihulls can go in shallow waters where monohulls can not. There are trade-offs, however, in multihull design. A well designed ballasted boat can recover from a capsize, even from turning over completely. Righting a multihull that has gotten upside down

232-402: A standing lug on the same side of the mast regardless of which tack they expected to be sailing on. Sailing performance with a standing lug relies on the right amount of luff tension. An essential component of this rig is the tack tackle, a purchase with which luff tension is adjusted for various points of sail. The balanced (or balance) lug has a boom that projects in front of the mast roughly

261-412: Is a type of boat having only one hull , unlike multihulled boats which can have two or more individual hulls connected to one another. Among the earliest hulls were simple logs, but these were generally unstable and tended to roll over easily. Hollowing out the logs into a dugout canoe doesn't help much unless the hollow section penetrates below the log's center of buoyancy, then a load carried low in

290-489: Is difficult in any case and impossible without help unless the boat is small or carries special equipment for the purpose. Multihulls often prove more difficult to tack, since the reduced weight leads directly to reduced momentum, causing multihulls to more quickly lose speed when headed into the wind. Also, structural integrity is much easier to achieve in a one piece monohull than in a two or three piece multihull whose connecting structure must be substantial and well connected to

319-461: Is easier for a short-handed crew to manage. A yawl is similar to a ketch, with a shorter mizzen mast carried astern the rudderpost more for balancing the helm than propulsion. Traditional sailboats are monohulls , but multi-hull catamarans and trimarans are gaining popularity. Monohull boats generally rely on ballast for stability and usually are displacement hulls. This stabilizing ballast can, in boats designed for racing, be as much as 50% of

SECTION 10

#1733085550294

348-436: Is similar to a sloop with a single mast and mainsail, but generally carries the mast further aft to allow for a jib and staysail to be attached to the head stay and inner forestay, respectively. Once a common racing configuration, today it gives versatility to cruising boats, especially in allowing a small staysail to be flown from the inner stay in high winds. A catboat has a single mast mounted far forward and does not carry

377-421: Is the sloop, which features one mast and two sails, typically a Bermuda rigged main , and a headsail . This simple configuration is very efficient for sailing into the wind. A fractional rigged sloop has its forestay attached at a point below the top of the mast, allowing the mainsail to be flattened to improve performance by raking the upper part of the mast aft by tensioning the backstay. A smaller headsail

406-469: Is what prevents leeway and allows sailing towards the wind. This can be an external piece or a part of the hull. Most monohulls larger than a dinghy require built-in ballast . Depending on the design of the boat, ballast may be 20 to 50 percent of the displacement. The ballast is often integrated into their keels as large masses of lead or cast iron. This secures the ballast and gets it as low as possible to improve its effectiveness. External keels are cast in

435-541: The mainmast of British three-masted luggers tended to be discarded, with larger sails being set on the fore and mizzen. This gave more clear space in which to work fishing nets . Sailboat Although sailboat terminology has varied across history, many terms have specific meanings in the context of modern yachting . A great number of sailboat-types may be distinguished by size, hull configuration, keel type, purpose, number and configuration of masts , and sail plan . Popular monohull designs include: The cutter

464-545: The 19th century in the coastal regions of the United States, particularly New England, where it was widely used by fishermen and sailors. With its straightforward design and uncomplicated rigging, the catboat offers a straightforward and laid-back sailing experience, making it an ideal choice for beginners and pleasure sailors alike. Even today, catboats continue to be cherished by enthusiasts who appreciate their heritage and enjoy their picturesque appearance while cruising through

493-461: The Zulu and many other sailing drifters ). Some larger examples might carry lug topsails . A lugger is usually a two- or three-masted vessel, setting lug sails on each mast. A jib or staysail may be set on some luggers. More rarely, lug topsails are used by some luggers — notably the chasse-marée . A lug sail is an asymmetric quadrilateral sail that fastens to a yard (spar) along the head (top edge) of

522-481: The bottom end in a receptacle that is supported above the keel of the boat or on the deck or other superstructure that allows the mast to be raised at a hinge point until it is erect. Some masts are supported solely at the keel and laterally at the deck and are called "unstayed". Most masts rely in part or entirely (for those stepped on the deck) on standing rigging , supporting them side-to-side and fore-and aft to hold them up. Masts over 25 feet (7.6 m) may require

551-601: The cavity actually stabilizes the craft. Adding weight or ballast to the bottom of the hull or as low as possible within the hull adds stability. Naval architects place the center of gravity substantially below the center of buoyancy ; in most cases this can only be achieved by adding weight or ballast. The use of stones and other weights as ballast can be traced back to the Romans , Phoenicians and Vikings . Modern ships carry tons of ballast in order to maintain their stability; even heavily laden cargo ships use ballast to optimize

580-532: The geometry of their design, the wide base of their multiple hulls, for their stability. Designers of performance multihulls, such as the Open 60's , go to great lengths to reduce overall boat weight as much as possible. This leads some to comment that designing a multihull is similar to designing an aircraft. A centreboard or daggerboard is retractable lightweight keel which can be pulled up in shallow water. On small sailboats, masts may be "stepped" (put in place) with

609-470: The hull itself has sufficient buoyancy to remain afloat. A multihull optimized for light weight (at the expense of cruising amenities and storage for food and other supplies), combined with the absence of ballast can result in performance gains in terms of acceleration, top speed, and manoeuvrability. The lack of ballast makes it much easier to get a lightweight multihull on plane, reducing its wetted surface area and thus its drag. Reduced overall weight means

SECTION 20

#1733085550294

638-450: The hulls. All these hull types may also be manufactured as, or outfitted with, hydrofoils . All vessels have a keel , it is the backbone of the hull. In traditional construction, it is the structure upon which all else depends. Modern monocoque designs include a virtual keel. Even multihulls have keels. On a sailboat, the word "keel" is also used to refer to the area that is added to the hull to improve its lateral plane. The lateral plane

667-573: The mainmast, but forward of the rudder post. The second mast is called the mizzen mast and the sail is called the mizzen sail. A ketch can also be Cutter-rigged with two head sails. A schooner has a mainmast taller than its foremast , distinguishing it from a ketch or a yawl. A schooner can have more than two masts, with the foremast always lower than the foremost main. Traditional topsail schooners have topmasts allowing triangular topsails sails to be flown above their gaff sails ; many modern schooners are Bermuda rigged. The most common modern sailboat

696-418: The sail. The yard is held to the mast either by a parrel or by a traveller (consisting of a metal ring that goes round the mast and has an eye for the halyard and a hook which fastens to a strop on the yard). A dipping lug sail is fastened at the tack (front lower corner) some distance in front of the mast, often at the stemhead . A standing lug's tack is fastened near the foot of the mast. The halyard for

725-612: The same distance as the yard. This is generally used in dinghies. The sail is left on the same side of the mast regardless of the wind direction. A downhaul is set up from the boom to a point close to the heel of the mast and its adjustment is critical to getting this sort of sail to set correctly. Luggers were used extensively for smuggling from the middle of the 18th century onwards; their fast hulls and powerful rigs regularly allowed them to outpace any Revenue vessel in service. The French three-masted luggers also served as privateers and in general trade. As smuggling declined from about 1840,

754-399: The shape of the keel. A monohull's keel is made effective by a combination of weight, depth, and length. Most modern monohull boats have fin keels, which are heavy and deep, but short in relation to the hull length. More traditional yachts carried a full keel which is generally half or more of the length of the boat. A recent feature is a winged keel , which is short and shallow, but carries

783-485: The various methods are time and labour consuming. A standing lug can be left unaltered when tacking as it still sets reasonably well with the sail pressed against the mast. Some users (such as in the Royal Navy Montagu whaler ) would still dip the yard of a standing lug (with a sharp, well timed downward pull on the leech at the moment when the wind is not filling the sail). Conversely many fishermen would always hoist

812-399: The waterways. A dinghy is a type of small open sailboat commonly used for recreation, sail training , and tending a larger vessel. They are popular in youth sailing programs for their short LOA , simple operation and minimal maintenance. They have three (or fewer) sails : the mainsail , jib , and spinnaker . Ketches are similar to a sloop, but there is a second shorter mast astern of

841-720: The weight of the boat, but is generally around 30%. It creates two problems; one, it gives the monohull tremendous inertia, making it less maneuverable and reducing its acceleration. Secondly, unless it has been built with buoyant foam or air tanks, if a monohull fills with water, it will sink. Multihulls rely on the geometry and the broad stance of their multiple hulls for their stability, eschewing any form of ballast. Some multihulls are designed to be as light-weight as possible while still maintaining structural integrity. They can be built with foam-filled flotation chambers and some modern trimarans are rated as unsinkable, meaning that, should every crew compartment be completely filled with water,

#293706